COMBUSTION PROCESS CONTROL
At various stages of burning your fireplace or stove needs different amounts of air. After the turbulent combustion stage you have to reduce the flow of air, otherwise the heat from the room will "escape" through the chimney. And why you should do this, as there is automation, it can even light the stove for you, and made the optimum amount of air throughout the combustion. This is accomplished through a combination of the following products of WGS-Austria- leading manufacturer of this type of equipment:
- Electronic control unit (DATA FIRE CONTROL)
There are three versions, depending on the process that will run, if fuel is firewood or pellets, and the number and type of control signals.
The device monitors the temperature of flue gases or the amount of carbon dioxide in them / provided the sensor is lambda- probe / and adjusts the amount of fresh air to always have complete combustion at high temperature. This leads not only to heat saving, but to fewer harmful emissions due to perfect combustion process. When the system is equipped with an ignition heater, electronic control unit can be set for the time of ignition of your stove, or to start after receiving a telephone message.
The most important data:
Multilingual menu, messages and errors protocol , possibility of updating the software at any time, management of: fireplace fan, dampers for fresh air or flue gas, ignition heater.